DIY TUTORIAL
Fuck Machine Stand

Presented & produced by: Loki

Content:

Intro
Needed
Buildup

The Improved Autofuck Machine Stand


Loki is a top with a passion for rubber and rope. And you can see more of his stuff on his website and twitter!

So our fucking machine had been stuck in a corner gathering dust as there was no easy way to arrange it to work against someone in the sling, when suspended in our bondage frame. On a whim, I decided to whip up a frame to hold it vertically (its legs only tilt +/- 30 degrees of horizontal and are quite short) to see if I might get some more use of it, especially as we enjoy suspending subs 🙂

Needed


If you want to build your own adapter for the F Machine Pro, you’ll need:

  • 6 x 23 cm of 33.7mm diameter tube
  • 2 x 50 cm of 33.7mm diameter tube
  • 4 x 90 degree elbow connectors
  • 6 x short T connectors
  • F Machine Pro (of course)
  • Screwdriver with bit for your pipe connector’s clamp screws

Lengths may need to be slightly adjusted for other Machines. When using different piping, please adjust all lengths for the size of the piping as well and make sure they fit your machine’s clamps, or you have padding to account for the difference.

Building the Stand


The buildup is relatively easy. Get the pieces in a hardware shop or online, and for the build, just put the pipes in the connecters, and screw them in. Make a square on the ground, with two T piece on opposite sides for the 50cm tubes to rise vertically. 4 Ts on the risers hold the F Machine in place – you’ll need to use some tape for a snug fit.

(Tip: Put in the tube for the fuckmachine first if you want to make sure they fit)

That’s it. You’re already done. Now go and enjoy the ride 😉


Loki is a top with a passion for rubber and rope. And you can see more of his stuff on his website and twitter!

LEAVE A REPLY

Please enter your comment!
Please enter your name here

This site uses Akismet to reduce spam. Learn how your comment data is processed.